Rar Paints

General product information

Ritver Platinum Emulsion is a top of the range specially formulated acrylic emulsion based latex paint pigmented with copious titanium dioxide and other high quality pigments exhibiting good alkali resistance properties. It has all the good virtues like hiding, good wash ability, superior scrub resistance, smooth finish, colour retention property and a superior finish. Its formulations are specially made to withstand the rigors of the external weather as well as the ambience of the interiors.



Substrates: Concrete, cement plaster, masonry, gypsum, block work etc.,
Area of Use: Interiors & Exterior application.


Finish:: Smooth & Matt
Colour:: White all shades as per Ritver shade card and custom made.
Specific gravity:: 1.39  0.05
Solids (% by volume):: 33  2
Diluent :: Sweet Water
Flash point :: Not Applicable
Spread Rate:
While the spread rate is directly dependant on the surface profile and also the type of undulations it has, over spray and also the equipment, the painter, Ritver Platinum Emulsion would cover app 8 7 m2 /liter at 40 50 microns per coat.
Drying Time (30 C) : Set to touch: 1 2 hours.
: Ready for Recoat: app 2 - 3 hours.
Recommended DFT: : 2 40 50 mic per coat.



A good surface preparation and following the method statement / recommended system procedure of Ritver is an ideal recommendation for the application of Ritver Platinum Emulsion.

For Plaster, Masonry & Concrete :
Achieve a good and clean surface by removing all contaminants and loose particles by cleaning & drying. A laitance free surface should be achieved by good sweep blast or a wire brush. Water washing under pressure is recommended.
Apply the Ritver Alkali resistant primer or Ritver Tex primer and allow drying as per the data sheet and subject to one more coat for even coverage. For Exterior: Apply Ritver filler compound (fine or coarse) evenly and allow drying and following it up with Ritver Platinum Emulsion for one or two Interior: After applying the Ritver AR primer, apply an uniform layer of Ritver Stucco putty and then follow it up with Ritver Platinum Emulsion two Old and Painted surfaces:
In case of surfaces which are painted / or aged and if there is visible dusting, chalking or even friable, ensure that all the loose material is removed by scrapping or metal brush. Apply a good coat Ritver Fungicidal wash compound and allow drying. Follow this by a regular coat or two of Ritver Alkali Resistant Primer and continue as in the above case with the full system.





Adequate ventilation is an ideal situation as it helps in drying and the good application itself. Avoid high humid conditions i..e., 95% when condensation is likely to interfere and also when the surface temperature is at least 3c above dew point.

1.Dilution: One can add 5 to 10% of sweet water for ease of application depending on the suitability of application.
2.Brush: It is in ideal recommendation especially to avoid runs and sags due to excess.
3.Roller: Apply an even coat spreading uniformly taking care to avoid runs.
4.Airless spray: Use tip size around 0018 to 0020 and pressure around 150. 175 Kg/cm.