Rar Paints

General product information

Ritver Gold Emulsion is an economical grade emulsion (VALUE FOR MONEY RANGE) based on copolymer with Titanium and other light fast alkali resistant pigments. It gives the surface a smooth and pleasing effect with good brush ability and is resistant to algae and fungus attacks.



Substrates: Concrete, plaster, masonry, gypsum,
Area of Use: Interiors only.



Finish:: Smooth & Matt
Colour:: White All shades as per Ritver shade card and custom made.
Specific gravity:: 1.45  0.05
Solids (% by volume):: 30  2
Diluent :: Sweet Water
Flash point :: Not Applicable
Spread Rate :
While the spread rate is directly dependant on the surface profile and also the type of undulations it has, over spray and also the equipment the painter Ritver Gold Emulsion it would cover app 8 m2 / liter at 40 microns per coat.
Drying Time (30 C) : Set to touch: 1 2 hours.
: Ready for Recoat: app 2 - 3 hours.
Recommended DFT: : 1 to 2 30 40 mic per coat.




A good surface preparation and following the method statement / recommended system procedure of Ritver is an ideal recommendation for the application of Ritver Gold Emulsion.

For Plaster, Masonry & Concrete :
Achieve a good and clean surface by removing all contaminants and loose particles by cleaning & drying. A laitance free surface should be achieved by good sweep blast or a wire brush. Water washing under pressure is recommended.
Apply the Ritver PVA Primer Sealer or Ritver Alkali Resistant Primer and allow drying as per the data sheet and subject to one more coat for even coverage. Apply Ritver Stucco Putty evenly and allow drying and following it up with Ritver Gold Emulsion for one or two Old and Painted surfaces:
In case of surfaces which are painted / or aged and is visible dusting, chalking or even friable ensure that all the loose material is removed by scrapping or metal brush. Apply a good coat Ritver Fungicidal wash compound and allow drying. Follow this by a regular coat or two of Ritver PVA Primer Sealer or Ritver Alkali Resistant Primer and continue as in the above case




Adequate ventilation is an ideal situation as it helps in drying and the good application itself. Avoid high humid conditions i.e., 95% when condensation is likely to interfere and also when the surface temperature is at least 3c above dew point.

1.Dilution: One can add 5 to 10% of sweet water for ease of application depending on the suitability of application.
2.Brush: It is in ideal recommendation especially to avoid runs and sags due to excess material.
3.Roller: Apply an even coat spreading uniformly taking care to avoid runs.
4.Airless spray: Use tip size around 0018 to 0020 and pressure around 150. 175 Kg/cm